Discussion ClosedThis discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one,click here.
Problem with mphplot
Posted 2011年2月25日 GMT+1 16:570 Replies
Please login with a confirmed email address before reporting spam
I am in the process of learning Livelink for Matlab. I have set up a simple 2D heat transfer question on the GUI. The geometry is a square, with T=100 on one side, no flux condition on the others.
After that, i saved the model as model m file and run it within matlab. In the last line of the model m file, i added:
mphplot(model,'pg1');
The plot result, however, shows T=0 everywhere. This is not the case when i run the model and plot the result within the GUI. What could have caused the problem?
Attached is my model m file.
Thanks in advanced.
After that, i saved the model as model m file and run it within matlab. In the last line of the model m file, i added:
mphplot(model,'pg1');
The plot result, however, shows T=0 everywhere. This is not the case when i run the model and plot the result within the GUI. What could have caused the problem?
Attached is my model m file.
Thanks in advanced.
Attachments:
0 Replies
Last Post 2011年2月25日 GMT+1 16:57
Hello Shu Heng Khor
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.