Note: This discussion is about an older version of the COMSOL Multiphysics®software. The information provided may be out of date.
Discussion ClosedThis discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one,click here.
Boundary current source
Posted 2012年2月10日 GMT+1 01:37Low-Frequency ElectromagneticsVersion 4.2a0 Replies
Please login with a confirmed email address before reporting spam
Hello, I am using ACDC module and I want to know how to create a high frequency current source to observe the current flow in the model.
Basically, I drew two surfaces inside the solid and apply a positive boundary current source to one surface and a negative current source with same amplitude to the other surface. But the result didn't show any electrical potential change or current flow inside the model.
Instead, if I apply a voltage potential to one surface and make the other one as the ground, the result came out well.
can anybody help me?
Basically, I drew two surfaces inside the solid and apply a positive boundary current source to one surface and a negative current source with same amplitude to the other surface. But the result didn't show any electrical potential change or current flow inside the model.
Instead, if I apply a voltage potential to one surface and make the other one as the ground, the result came out well.
can anybody help me?
0 Replies
Last Post 2012年2月10日 GMT+1 01:37
Hello He Huang
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.