Note: This discussion is about an older version of the COMSOL Multiphysics®software. The information provided may be out of date.
Discussion ClosedThis discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one,click here.
2D Depth in 4.3a
Posted 2013年11月10日 GMT+1 23:12Heat Transfer & Phase Change, GeometryVersion 4.3a1 Reply
Please login with a confirmed email address before reporting spam
I am relatively new to COMSOL. I am using version 4.3a. My issue is with heat transfer in solids, specifically the depth to my geometry. It is my understanding that the default depth is 1m. Since my model's scale is much smaller than this, mm, it throws off all off the calculations.
My question is how do I change the default depth to a specified depth. Should I simply make a 3d model instead? I was hoping to compare both 2d and 3d computations.
Thank you for any advice/help
Hello Kegan Dellinger
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.
Please login with a confirmed email address before reporting spam
Thanks in advance.