Note: This discussion is about an older version of the COMSOL Multiphysics®software. The information provided may be out of date.
Discussion ClosedThis discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one,click here.
Parametric Sweep
Posted 2013年3月25日 GMT+1 10:47Fluid & Heat, Heat Transfer & Phase Change, Computational Fluid Dynamics (CFD), Modeling Tools & Definitions, Parameters, Variables, & Functions, Results & Visualization, Studies & SolversVersion 4.3a1 Reply
Please login with a confirmed email address before reporting spam
Can I know how to use parametric sweep??
1 Reply
Last Post 2013年3月25日 GMT+1 13:16
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
it has been discussed a dozen time on the Forum, and it's rather well described in the doc and examples, try a search:
Note that you have 2 types: the continuation type, one model you vary a parameter inside of some physics but your geometry is not changing, and the "external one when you loop around the full geometry and re-meshing as the parameters changes the geometry
There are hence 2 ways to select or add parameter-sweep nodes
--
Good luck
Ivar
it has been discussed a dozen time on the Forum, and it's rather well described in the doc and examples, try a search:
Note that you have 2 types: the continuation type, one model you vary a parameter inside of some physics but your geometry is not changing, and the "external one when you loop around the full geometry and re-meshing as the parameters changes the geometry
There are hence 2 ways to select or add parameter-sweep nodes
--
Good luck
Ivar