Note: This discussion is about an older version of the COMSOL Multiphysics®software. The information provided may be out of date.
Discussion ClosedThis discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one,click here.
Issue with multiply frequencies on a dipole antenna.
Posted 2013年10月4日 GMT+2 01:53RF & Microwave EngineeringVersion 4.30 Replies
Please login with a confirmed email address before reporting spam
So, I'm using the standard simulation of a dipole antenna(link below) and every thing worked fine, but when I try to use the range when on the Study 1>Study Setting>Frequencies the program try to simulate and after almost a day will give me an error message saying that the "Comsol failed to find a solution for the iticial parameter matrix has zero on diagonal".
I'm trying to make a simulation to observe the behavior of the impedance when I vary the frequencies.
link: www.comsol.com/model/modeling-a-dipole-antenna-8715
I'm trying to make a simulation to observe the behavior of the impedance when I vary the frequencies.
link: www.comsol.com/model/modeling-a-dipole-antenna-8715
0 Replies
Last Post 2013年10月4日 GMT+2 01:53
Hello Guilherme Silvano
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.