Note: This discussion is about an older version of the COMSOL Multiphysics®software. The information provided may be out of date.
Discussion ClosedThis discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one,click here.
Is this a cpu problem?
Posted 2015年5月24日 GMT+2 12:53Mesh, Results & Visualization, Studies & SolversVersion 4.30 Replies
Please login with a confirmed email address before reporting spam
My system has windows 7 ultimate x64, intel i7, 32GB of RAM, no graphic card.
I made my simulation using my system and could solve my simulation over one hours.
There was a problem with my computer, it was the format.
After my computer was the format, my computer can't solve my simulation.
I am getting this message "out of memory during assembly" or "out of memory during LU factorization." over ten minutes.
I check the performance of CPUs from windows task manager, usage of RAM is 5GB but usage of CPU is 100%.
As soon as to 100%, an error message occurs.
So I do the inspection of computer viruses, but doesn't exist computer viruses.
After I do reset BIOS setup, I can decrease 90%.
But I am getting error message yet.
I decrease meshes of simulation more then 10 times.
This solution has residual error rate 80% before computer format.
I do format my computer again, but can't solve problem still.
How can I solve this problem?
I made my simulation using my system and could solve my simulation over one hours.
There was a problem with my computer, it was the format.
After my computer was the format, my computer can't solve my simulation.
I am getting this message "out of memory during assembly" or "out of memory during LU factorization." over ten minutes.
I check the performance of CPUs from windows task manager, usage of RAM is 5GB but usage of CPU is 100%.
As soon as to 100%, an error message occurs.
So I do the inspection of computer viruses, but doesn't exist computer viruses.
After I do reset BIOS setup, I can decrease 90%.
But I am getting error message yet.
I decrease meshes of simulation more then 10 times.
This solution has residual error rate 80% before computer format.
I do format my computer again, but can't solve problem still.
How can I solve this problem?
0 Replies
Last Post 2015年5月24日 GMT+2 12:53
Hello Lee HJ
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.