Note: This discussion is about an older version of the COMSOL Multiphysics®software. The information provided may be out of date.
Discussion ClosedThis discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one,click here.
How to use Matlab commands to simulate in COMSOL
Posted 2011年3月10日 GMT+1 00:28Version 4.11 Reply
Please login with a confirmed email address before reporting spam
Can I just write commands in matlab and run it in COMSOL?
Like Ansys, I could write command flow and click run to get the results I want.
Thanks.
Like Ansys, I could write command flow and click run to get the results I want.
Thanks.
1 Reply
Last Post 2011年3月10日 GMT+1 06:58
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
yes and no ;)
read the doc, you can set up your model, or load it in and control the solving from matlab, but its not "just one command"
--
Good luck
Ivar
yes and no ;)
read the doc, you can set up your model, or load it in and control the solving from matlab, but its not "just one command"
--
Good luck
Ivar