Menu

Discussion Forum

New Discussion
查找

Discussion ClosedThis discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one,click here.

Dielectrophoretic Force Model problem

Posted 2018年5月4日 GMT+2 12:26Electromagnetic Heating, Low-Frequency Electromagnetics, MEMS & NanotechnologyVersion 5.2a1 Reply

揚愉 張
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello, I am trying to do a DEP simulation in Comsol 5.2a and I want to apply an AC signal of 90V-pp 3KHz in a pair of electrodes.I am presently using AC/DC model , I try to use Particle Tracing for Fluid model and Transport of Diluted Species model . My question is how to set up model in Comsol Please help me, my complete project depends on this.

1 Reply Last Post 2018年5月9日 GMT+2 09:05
Ismail Hussain
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 6 years ago 2018年5月9日 GMT+2 09:05

Dear 揚愉 張,

The dielectrophoresis model is readily available in COMSOL. Please refer this link: https://www.comsol.com/model/red-blood-cell-separation-17013. Hope this helps.

Regards, Ismail

Dear 揚愉 張, The dielectrophoresis model is readily available in COMSOL. Please refer this link: https://www.comsol.com/model/red-blood-cell-separation-17013. Hope this helps. Regards, Ismail

Note that while COMSOL employees may participate in the discussion forum, COMSOL®software users who are on-subscription should submit their questions via theSupport Centerfor a more comprehensive response from the Technical Support team.

Suggested Content

Baidu
map