Note: This discussion is about an older version of the COMSOL Multiphysics®software. The information provided may be out of date.
Discussion ClosedThis discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one,click here.
The power transmission is bigger than 1???
Posted 2011年6月23日 GMT+2 05:42Acoustics & VibrationsVersion 4.1, Version 4.21 Reply
Please login with a confirmed email address before reporting spam
frequency domain:
a rectuanger strucutre
the periodic condition is applied upon the left and right boundaries. the plane radiation boundary is applied upon the up and down boundries. the incidence wave with pressure p0 is applied on the up boundary.
I calculate the power transmission like this: w_in=intop1(p0^2/(2*acpr.rho*acpr.c)); w_out=intop2(abs(p)^2/(2*acpr.rho*acpr.c)); and trans=w_out/w_in. the inop1 and intop2 is intergations in incidence boundary and out boundary..
for most conditions, the trans smaller than 1, but in some simulation, the trans bigger than 1...
did some one encounter the same question? how you guys fix it?
best wishes...
Kyo
Hello Yong LI
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.
Please login with a confirmed email address before reporting spam
Did you succeed in resolving the issue yet? If yes what was the explanation?
If not, and you are still interested in it, please attach your .mph file.
I will take a look into it.
Regards,
Joe