Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics®software. The information provided may be out of date.

Discussion ClosedThis discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one,click here.

Change default boundary condition

Posted 2011年12月23日 GMT+1 14:42Fluid & Heat, Heat Transfer & Phase ChangeVersion 4.21 Reply

Bastian Schmitt
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi everybody,


can anybody please tell me how to change a default boundary condition. For example the default value for "Wall" is "No Slip". This is not reasonable in my case, so I want to change it to "Slip".


Thanks a lot!


Bastian
1 Reply Last Post 2011年12月23日 GMT+1 17:05
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2011年12月23日 GMT+1 17:05
Hi

Normally it's "just" to select the (no-slip) roll down tab and choose another BC conditions, if not you can always write out the equations yourself, but it's somewhat more tedious ...

--
Good luck
Ivar
Hi Normally it's "just" to select the (no-slip) roll down tab and choose another BC conditions, if not you can always write out the equations yourself, but it's somewhat more tedious ... -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL®software users who are on-subscription should submit their questions via theSupport Centerfor a more comprehensive response from the Technical Support team.

Suggested Content

Baidu
map