Menu

Discussion Forum

New Discussion
查找

Discussion ClosedThis discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one,click here.

Setting materials and boundaries for complex structure

Posted 2020年10月26日 GMT+1 09:03General, Geometry, MaterialsVersion 5.51 Reply

Guilherme Theis
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

I am simulating the heat transfer in a via array which has 144 vias. My final geometry has 867 Geometric Entities (Material tab) and over 4000 Boudaries that can be selected. I know this might be a basic question, but how can I have an easier time setting the materials and boundaries?

You have the file attached to this post. Thanks in advance.

Attachments:

1 Reply Last Post 2020年10月27日 GMT+1 08:07
Henrik Sönnerlind COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 5 years ago 2020年10月27日 GMT+1 08:07

Creating named selections at the same time as you create the objects in the geometry sequence can be useful here. Use the sectionSelection of Resulting Entitiesin the various geometry nodes.

-------------------
Henrik Sönnerlind
COMSOL
Creating named selections at the same time as you create the objects in the geometry sequence can be useful here. Use the section *Selection of Resulting Entities* in the various geometry nodes.

Note that while COMSOL employees may participate in the discussion forum, COMSOL®software users who are on-subscription should submit their questions via theSupport Centerfor a more comprehensive response from the Technical Support team.

Suggested Content

Baidu
map