Menu

Discussion Forum

New Discussion
查找

Discussion ClosedThis discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one,click here.

Why do the stress results differ from same model and same situation?

Posted 2023年10月10日 GMT+2 05:492 Replies

H Z
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello dear scientists, Hope all is well! I have a very simple model,just a steel box.The fixed constraints are all at the bottom, and the boundary load is applied externally with a pressure of 0.1MPa. The only difference between the two is the positive pressure+0.1MPa in the figure above and the negative pressure -0.1MPa in the figure below. It is reasonable to say that the stress values calculated by the two should be the same. Why is there a slight difference in the actual calculation? One is 229MPa, and the other is 223MPa.https://img1.imgtp.com/2023/10/10/Ats8aFuf.pnghttps://img1.imgtp.com/2023/10/10/g2p1A1Nw.png

2 Replies Last Post 2023年10月12日 GMT+2 03:28
Henrik Sönnerlind COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 11 months ago 2023年10月11日 GMT+2 11:50

If the stresses differ with only a sign change in the load, then there must be some nonlinearity in action. Is geometric nonlinearity activated?

If you increase/decrease the load by, for example, a factor of 5, what happens to the stress values?

-------------------
Henrik Sönnerlind
COMSOL
If the stresses differ with only a sign change in the load, then there must be some nonlinearity in action. Is geometric nonlinearity activated? If you increase/decrease the load by, for example, a factor of 5, what happens to the stress values?
H Z
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 11 months ago 2023年10月12日 GMT+2 03:28

If the stresses differ with only a sign change in the load, then there must be some nonlinearity in action. Is geometric nonlinearity activated?

If you increase/decrease the load by, for example, a factor of 5, what happens to the stress values?

DEAR Mr Sönnerlind: Thank you very much for reply,and your suggest really helped me,it works,the stress values become to the same,whatever the factor changed or not,they're linearity now. I just didn't notice that the default is nonlinearity in Comsol,and the most important thing is I didn't realize that nonlinear calculations would be affected by sign change, I should learn more about nonlinear theory. Thank you again. Best regards.

>If the stresses differ with only a sign change in the load, then there must be some nonlinearity in action. Is geometric nonlinearity activated? > >If you increase/decrease the load by, for example, a factor of 5, what happens to the stress values? DEAR Mr Sönnerlind: Thank you very much for reply,and your suggest really helped me,it works,the stress values become to the same,whatever the factor changed or not,they're linearity now. I just didn't notice that the default is nonlinearity in Comsol,and the most important thing is I didn't realize that nonlinear calculations would be affected by sign change, I should learn more about nonlinear theory. Thank you again. Best regards.

Note that while COMSOL employees may participate in the discussion forum, COMSOL®software users who are on-subscription should submit their questions via theSupport Centerfor a more comprehensive response from the Technical Support team.

Suggested Content

Baidu
map