Note: This discussion is about an older version of the COMSOL Multiphysics®software. The information provided may be out of date.
Discussion ClosedThis discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one,click here.
Encountering error during meshing
Posted 2013年6月13日 GMT+2 06:36MeshVersion 4.3b2 Replies
Please login with a confirmed email address before reporting spam
when I try to run a mesh i encounter the following error message: "Edge is much shorter than the specified minimum element size." I do not know what this means and any advice on how to get rid of this error would be very helpful
2 Replies
Last Post 2013年6月28日 GMT+2 14:42
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
If necessary I can upload the file in question if that will help any
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Doyle-
I believe what you are describing is simply a warning not an error.
You can get rid of the warning by decreasing the minimum element size in the Size settings of your mesh operation. This minimum element size is ignored if you have any small geometric entities that need to be resolved by the mesher. Hence, the warning.
Best regards,
Josh Thomas
AltaSim Technologies
I believe what you are describing is simply a warning not an error.
You can get rid of the warning by decreasing the minimum element size in the Size settings of your mesh operation. This minimum element size is ignored if you have any small geometric entities that need to be resolved by the mesher. Hence, the warning.
Best regards,
Josh Thomas
AltaSim Technologies