Discussion Forum

Forum Home

New Discussion

Note: This discussion is about an older version of the COMSOL Multiphysics^®software. The information provided may be out of date.

Discussion ClosedThis discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one,click here.

Cutting a simple geometry in half

Posted 2013年7月1日 GMT+2 10:32GeometryVersion 4.3, Version 4.3a, Version 4.3b2 Replies

sebastian

Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I'm trying to cut a relatively simple 3D geometry in half. My approach is to first partition the geometry using a work-plane and then delete the entities that I don't want. Unfortunately, some parts of the geometry, i.e. the circular faces of the cylinders, do not get cut in half. Is there any (easier) way to achieve this? I attached the geometry.

Attachments:

13-07-01_inlet.mph

2 Replies Last Post 2013年7月12日 GMT+2 18:08

Sergei Yushanov Certified Consultant

Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago

Sebastian,

Attached is half of your geometry.

Regards,
Sergei

Attachments:

13-07-01_inlet_sy.mph

sebastian

Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago

thanks! :-)

Note that while COMSOL employees may participate in the discussion forum, COMSOL^®software users who are on-subscription should submit their questions via theSupport Centerfor a more comprehensive response from the Technical Support team.

Discussion Forum

Cutting a simple geometry in half

Suggested Content