Note: This discussion is about an older version of the COMSOL Multiphysics®software. The information provided may be out of date.
Discussion ClosedThis discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one,click here.
error message!!!!
Posted 2013年11月16日 GMT+1 12:31Version 4.32 Replies
Please login with a confirmed email address before reporting spam
Hello
I am getting the following error message
"Out of memory during assembly".
How to overcome that?
rgds
Anup
I am getting the following error message
"Out of memory during assembly".
How to overcome that?
rgds
Anup
2 Replies
Last Post 2013年11月17日 GMT+1 09:39
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
You can try by changing the mesh type to normal..coarse ....If you dont see the error again that means the problem is on the memory of your computing machine.
You can try by changing the mesh type to normal..coarse ....If you dont see the error again that means the problem is on the memory of your computing machine.
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
That's fine.
Now I got a new prob.
Actually I am using two different (coupled) physics in my model.
When I am running the Study-1(Physics 1) it's absolutely fine.
But, When I try to run Study-2 (Physics 2), "Out of memory in time-dependent solver" error appears and then terminate the program.
rgds
Anup
That's fine.
Now I got a new prob.
Actually I am using two different (coupled) physics in my model.
When I am running the Study-1(Physics 1) it's absolutely fine.
But, When I try to run Study-2 (Physics 2), "Out of memory in time-dependent solver" error appears and then terminate the program.
rgds
Anup