Discussion ClosedThis discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one,click here.
[Application Builder] Accessing Mesh Nodes
Posted 2015年4月8日 GMT+2 15:42Simulation Apps, Mesh0 Replies
Please login with a confirmed email address before reporting spam
Hello everybody,
I am looking for a possibility to access and edit the physical properties of single nodes in a mapped and swept three dimensional mesh.
The problem is that I have a complex geometry which consists of a cube containing very small and randomly distributed cylinders. I would prefer not to create a geometry for each cylinder, as these could be thousands.
Rather I would like to create a java class for each cylinder and than access the intersecting nodes of the mesh and edit the corresponding physical properties (In my case for example mass transport, heat transfer coefficient and specific heat capacity).
As far as I found out, this is not possible or am mistaken?
Kind regards,
Finn Bosholm
I am looking for a possibility to access and edit the physical properties of single nodes in a mapped and swept three dimensional mesh.
The problem is that I have a complex geometry which consists of a cube containing very small and randomly distributed cylinders. I would prefer not to create a geometry for each cylinder, as these could be thousands.
Rather I would like to create a java class for each cylinder and than access the intersecting nodes of the mesh and edit the corresponding physical properties (In my case for example mass transport, heat transfer coefficient and specific heat capacity).
As far as I found out, this is not possible or am mistaken?
Kind regards,
Finn Bosholm
0 Replies
Last Post 2015年4月8日 GMT+2 15:42
Hello Finn Bosholm
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.