Discussion ClosedThis discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one,click here.
Single Coil Gap Feed Problem
Posted 2015年4月10日 GMT+2 16:25Low-Frequency ElectromagneticsVersion 5.01 Reply
Please login with a confirmed email address before reporting spam
Hii all,
I am trying to simulate a simple geometry and I am having problems in giving a particular value of current through the gap feed. The problem is the current density shows always zero.
Can someone help ? I have attached my model herewith.
www.dropbox.com/s/kktoh7c3rpxqam6/PCB_3Dmodel2.mph?dl=0
Thank you.
Regards,
Anup
I am trying to simulate a simple geometry and I am having problems in giving a particular value of current through the gap feed. The problem is the current density shows always zero.
Can someone help ? I have attached my model herewith.
www.dropbox.com/s/kktoh7c3rpxqam6/PCB_3Dmodel2.mph?dl=0
Thank you.
Regards,
Anup
1 Reply
Last Post 2015年4月13日 GMT+2 12:32
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi Anup,
as in your other forum post - the coil feature in your model did comprise more entities than needed,
thereby not creating a regular coil. See my suggestion.
I have deleted all solutions and meshes tho have the model small for transmission in the forum - it solves in 55s.
Best regards,
Sven
as in your other forum post - the coil feature in your model did comprise more entities than needed,
thereby not creating a regular coil. See my suggestion.
I have deleted all solutions and meshes tho have the model small for transmission in the forum - it solves in 55s.
Best regards,
Sven
Attachments: