Note: This discussion is about an older version of the COMSOL Multiphysics®software. The information provided may be out of date.
Discussion ClosedThis discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one,click here.
Plane symmetries and cylindrical systems
Posted 2012年8月6日 GMT+2 11:48GeometryVersion 4.31 Reply
Please login with a confirmed email address before reporting spam
Dear reader,
The default coordinate system in a 2D environment is an X,Y plane. If I was to add a cylindrical system phi would go from X to Y in an arc.
But what I would like is to have the 2D environment in a Y,Z plane, so that if i was to add a cylindrical system phi would go from X yo Y in an arc. This would give me the possiblity to have a plane symmetrical environment.
Am I able to change this things? And how should I go about changing the right settings?
Thanks in advance.
If my questions are vague in any way please do point this out. I'll change the formulation.
The default coordinate system in a 2D environment is an X,Y plane. If I was to add a cylindrical system phi would go from X to Y in an arc.
But what I would like is to have the 2D environment in a Y,Z plane, so that if i was to add a cylindrical system phi would go from X yo Y in an arc. This would give me the possiblity to have a plane symmetrical environment.
Am I able to change this things? And how should I go about changing the right settings?
Thanks in advance.
If my questions are vague in any way please do point this out. I'll change the formulation.
1 Reply
Last Post 2012年8月6日 GMT+2 16:09
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
you have the 2D-axi system in r,z (instead of x,y) but if you want a cylindrical system with Z out of the paper (and not phi as in 2D-axi) use the standard 2D (x,y) and dfine a local cylindrical coordiante system, you access by sys2.r and sys2.phi (if this is the first coordinate system you add, under the Definitions node)
--
Good luck
Ivar
you have the 2D-axi system in r,z (instead of x,y) but if you want a cylindrical system with Z out of the paper (and not phi as in 2D-axi) use the standard 2D (x,y) and dfine a local cylindrical coordiante system, you access by sys2.r and sys2.phi (if this is the first coordinate system you add, under the Definitions node)
--
Good luck
Ivar